Animated Lighting Quick Reference and Troubleshooting
(564 KB)
Look in here for information on a variety of summary and troubleshooting topics on Animation Director, the Visualizer, and hardware/network connections
.
Description of Lighting Effects
(81 KB)
This document describes each of the lighting effects our light controllers can
perform. Each channel on a given controller can perform each lighting
effect listed independently of other channels on the same controller.
How to Build Macros
(70 KB)
This document provides an overview of programming macros with Animation Director.
How to control landscape
lighting (12VAC) with a Power Prism LD16
(41 KB)
A schematic of how to wire a LD16-T to a landscape lighting transformer to
control 12VAC lights. Please note that this controller will not adjust the
output voltage when a light goes out.
"Music Sync Made Easy" (3.56
MB) What hardware do you need to deliver music as part of a
light show? How do you load music into Animated Lighting controllers? How should
you hang your lights to match the pre-programmed shows? Find out the answers you
need in this quick-read eight page document.
Use this spreadsheet to quickly organize and calculate electrical loads for
your display. It can load your light channel configuration from any Animation
Director v4 show file and create a worksheet tab for each light controller in
your display. Created by Mike Mulvenna for fellow holiday display enthusiasts.
Pro Series Package Installation Guide
(476 KB)
Use this guide to learn how to install a plug-and-play PO16-MB or PO8-MB without any custom programming.
What to Know About Setting Up Your Show
(2.98 MB)
This document will present some of the issues you will want to consider before starting to build your show.
Wiring diagram for DMX to RJ45 adapter
(137 KB)
Pin out of an adapter cable that has a 3- or 5-pin XLR connector (used in
DMX installations) on one end and a RJ45 connector on the other end. The
adapter is used to interface our Power Prism DMX controllers to a typical DMX
data bus.
